Treat yourself to the best. The Epix+ series stands out from the crowd with a uniquely designed, sporty aesthetic, developed with today's modern vehicles in mind. EPIX20+ Work strobe is a work bar with approved R65 strobe lights that ensure your visibility. Choose between red or yellow-orange position light.

The Epix+ series stands out with its proprietary, sporty design tailored for modern vehicles. The Epix20+ Work Strobe is a work light bar with selectable red or yellow/orange position lights and R65-approved strobe lights for high visibility. The position lights are unique in that they are fully integrated into the reflector. 
The Epix20+ Work Strobe combines modern aesthetics with performance for demanding work environments. The 180 W output provides a work light with a range of 143 m at 1 lux and a wide 120° beam pattern, providing maximum light over large areas. With 11800 actual lumen and a colour temperature of 5000 K, it creates strong and natural lighting that facilitates work in varying conditions. Proprietary smart mounts provide great flexibility during installation and allow placement virtually anywhere on the vehicle. 

Position light 
The work light bar is equipped with the Epix series' specially designed reflectors with dynamic position light activation, fully integrated into the reflector. The colour of the position light can be selected between yellow/orange and red, which is ECE R148 approved. 

Strobe light 
The Epix20+ Work Strobe has 10 different strobe light patterns, one of which is ECE R65 approved.

DT relay set 
The use of the Ledson Connect cable set with 1 x 6-pin (item no. 7801006) is strongly recommended. Ledson Connect provides a very simple connection and is also interconnectable for future needs to add more auxiliary lights or ramps. 


The package includes the Epix20+ Work Strobe LED bar and bolts and screws for mounting on a suitable surface. Mounting hardware for both end and rear mounting, standing or hanging, is also included. The ramp is supplied with a 6-pin DT connector and requires a separate 6-pin cable set. Installation instructions are included.



Flash patterns: 
Single flash synchronised: 2.2 Hz 
Single flash asynchronous: 2.2 Hz 
Triple flash synchronised: 1.1 Hz 
Triple flash asynchronous: 1.1 Hz 
Quadruple flash synchronised: 1.25 Hz 
Quadruple flash asynchronous: 1.25 Hz 
Combination (one long and five short) synchronised: 0.83 Hz 
Combination (one long and five short) asynchronous: 0.83 Hz 
Flash series synchronised: 10 Hz 
Flash series asynchronous: 10 Hz

NOTE: The DT connector must not be cut, as this increases the risk of moisture damage and voids the warranty.