Ledson Xtreme DX is a complete kit for LED conversion of your original xenon or halogen headlight bulbs. The change of bulbs is incredibly easy as the Xtreme DX is connected directly to your current original ballast (if you have xenon) or connected to the vehicle's original connector (if you have halogen)! In just a few moments, you have up to 220% stronger light with a sharp light and correct beam pattern, a longer lifespan of about 30,000 hours and immediate ignition. With Xtreme DX it is very easy to give your vehicle a much stronger light and avoid time-consuming bulb changes.

Xtreme DX is a complete kit for LED conversion of your original xenon bulbs and halogen bulbs on your low beam and high beam. Works for cars (12V) and trucks (24V) if you have xenon and for cars (24V) if you have halogen.

Xtreme DX detailed information

• Easily convert original xenon & halogen to LED
• Plug and Play - connects directly to your original ballast (if you have xenon)
• Plug and Play - connects directly to your original connector (if you have halogen)
• Comes with two Xtreme DX bulbs for a complete conversion
• Up to 220% stronger light
• Sharp beam pattern as original xenon & halogen
• Longer service life (30,000 hours)
• 6000-6500K color temperature
• Up to 6000 lumens per bulb
• Works for 12V and 24V (for xenon) and 12V (for halogen)
• Canbus secured (no error messages on most vehicles)
• EMC secured (no interference in the radio)
• Efficient cooling with fan + heat sink
• 36 month warranty

Mounting in the vehicle (xenon):

1. If necessary, loosen the headlight
2. Check how the electrical connector is mounted on the existing bulb and disconnect it
3. Release the spring clip of the HID bulb, then remove the HUD bulb
4. Only for D2S / R or D4S / R: Mount the detachable mounting sleeve in the headlight
5. Install the Xtreme DX bulb in the headlight, connect the power unit to the original ballast
6. Place the power unit and ballast in the headlight
7. Finished!

Mounting in the vehicle (halogen):

1. Loosen any screws that hold the bulb holder (some types do not have screws) and then mount the bulb holder in the housing
2. Insert the Xtreme DX bulb into the headlight and rotate to the correct position
3. Finally, connect the bulb to the drive unit and the vehicle's original connector
4. Finished

Technical Information:

UV-shielded No
Quick start ballast No
Polarity dependent No
Electronic thermal management (ETM) No
Unit Pair
Canbus Yes
Supplied in pairs
Function Low beam, High beam
Voltage 24 V
Light source LED
Socket H4
Start time, cold to full Instant